40PIN HDMI To EDP Driver Board EDP Signal LCD Screen Driver Adapter Portable LCD Display Projection 2K 4K 60hz 120Hz 144hz Cable

40PIN Micro HDMI to EDP driver board EDP Signal LCD screen driver Adapter Portable LCD Display Projection 2K 4K 60hz 120Hz 144hz

Only supported the EDP output signal screen.Only supported 40PIN LCD screen

not supported LVDS output screen

When purchasing. Please search the parameters of the query screen

A function description:

1. In the initial state, insert the power cable and start the product. The default backlight brightness is 50% on startup. (< 1S). You can     adjust the brightness by flipping the wheel switch. Press ON/OFF vertically.

2. The device does not support hot swap. Disconnect the Type-c power supply when removing the HDMI socket. Do not plug and           unplug EDP cables while live. The screen may be damaged. The power must be turned off first in order. All ports are removed. The     EDP cable can be removed at last.

3.EDP40 coaxial signal output.microHDMI port supports 1920*1080/120HZ,1920*1200/144HZ, 2560*1440/120HZ,                      2560*1600/120HZ, 3200*1800/48HZ, 3840*2160/60HZ, 3840*2400/60HZ compatible with 16:9/16:10 conventional resolution. Supports 360 Xbox.PS5 (requires 1920*1080 screen). Does not support 4:3 ratio screen or other unconventional resolution screen. Does not support scaling function (the main device input is 1080 resolution can only use 1080 resolution screen. Input 4K signal can only use 4K screen. And so on. If the host supports multiple resolutions. That is, the resolution screen listed above is supported.

Two performance parameters:

Operating voltage 5V/PD15V protocol. Compatible with QC protocol, automatic identification of charger fast charge protocol features, support 60W PD protocol power charger; Current 2~5A. (A C TO C charging cable can only support PD protocol, and A to c only supports 12V protocol)

TYPE-C is the power input, supports PD protocol, DP/QC, EDP40 is the signal output, (40PIN is 4LAN), the backlight voltage is 15V by default, and the drive logic voltage is 3.3V.

Keystrokes: 50,000 times.

Operating temperature: -40-85℃

Dimming frequency 1KHZ. (non-polar dimming 8%-100% brightness) Adjust the minimum brightness to the maximum brightness for 3 seconds after downtuning

HDMI does not support audio transmission so the USB expansion port must be plugged into the computer to use audio.

Support key control brightness and switch (SW1 dial switch)